55KW Air Bearing levitation Centrifugal Blower with Constant Pressure for Melt-blown Non-woven Fabric Production

33-74 m³/min Air Bearing-levitation Centrifugal Blower - the Great Substitute for Ball Bearing Blower

Introduction

The air suspension blower is suitable for deep aeration in leachate treatment plant. It can perfectly work at a depth of 10 m in the aeration tank without any problem, so it can fully adapt to the general aeration depth of the leachate plant at present.

So far, many leachate treatment plants still use roots blowers,which have the disadvantages of high energy consumption and high maintenance cost. With the air suspension blower technology becoming more and more mature, and the air suspension blower has the advantages of lower energy consumption,lower maintenance cost. Therefore,it is quite urgent to replace the existing roots blower with the air suspension blower for energy saving.

Application Fields

Municipal water treatment

Sewage disposal in textile printing and dyeing plants

Waste water treatment in paper making industry

Waste water treatment in petrochemical plant

Desulfurization and oxidation treatment in thermal power plant

Food and medicine plants

Electronic factories

Cement plants......

Feature

Air bearing is different from traditional ball bearing. There is no physical contact point between the rotating shaft and the bearing during operation,

Daily maintenance

1. To replace the filter cotton at the air inlet and shut down the filter when the pressure difference of the filter screen is close to 3 kPa. Filter cotton can be reused for 2-3 times to reduce the cost of maintenance materials by washing and purging.
2. In daily use, the machine can work under most working environments, it doesn’t have high requirements for the working environment, basically as long as the blower room is clean and ventilated.

Service

GooDSeaA has established a good after-sales service system to provide customers with full support from beginning to end in time:

1. During the before- sales stage, answer questions for customers about equipment selection and production efficiency planning；
2. During the in-sales stage, provide professional and technical guidance on equipment layout and equipment installation；
3. During the after-sales stage, provide on-site training on equipment commissioning, operation and maintenance；
4. Provide lifelong service of supplying spare parts for equipment maintenance, helping solve any problem occur during equipment operation which reassures customers that there is no worry about the supply of spare parts, faults handling and any relevant after-sales service problem.